-
Signlab Male tool path. please help
Instead of my male tool path putting nice square corners on the selected object. The tool path is putting rounded corners on my object. How do i change this back. please help!
-
13 Replies
-
Do yourself a favor Buddie and take 5 minutes to introduce yourself to the site properly, then I’m sure some member with the answer will spend 5 minutes to tell you.
Welcome to the site 🙂
-
thanks for your help friend! so kind
-
your welcome!
-
Ok, i want to take a moment to introduce myself properly! I am 28 yrs old from spokane, wa usa. i was born into a family of ten. I am a single dad of three wonderful children. I am 235 and 6ft tall. my name is Ronnie Uzeta. now that i have introduced myself properly, can u answer my question?
-
There is a section where people can introduce them selves.
Its called the "Say Hello" section 😀
Welcome to the boards
-
Check your corner styles settings it may be that.
-
because I don’t use signlab myself I done a quick search for your answer but with no joy, most members will be travelling home right now but i’m sure you’ll have your answer shortly 🙂
-
What do you mean by "male tool path"
If you select the object > Right Click a node > then click the cross
This will change it from being rounded node
-
Scot
I think we are talking about engrave lab here, correct me if I’m wrong Ronnie
anyway welcome aboards,
cant help with your problem.
but I’m sure someone will have the answer.Peter
-
Its defo an engravelab function – I’d say check what cutter you are choosing when setting the tool path. If you’re choosing one with a wide tip size then the blue simulation line will simulate a rounded corner – choose a smaller tip size and the "rounding" wont be as noticable.
Andy
-
Hi Ronnie
Within Signlab ‘cut’ tab there are options for various tool paths, which I assume are for engraving, but I am afraid I have no idea how to use them!
Sorry I am unable to help!
Welcome to the boards, by the way.Lorraine
-
With Engravelab, it you want to follow the line, then use "on line" tool option. Inside, outside paths allow for automatic off-set from the drawn line for differing tool profiles and cut depths.
As this is modular software, Im guessing your signlab has an engravelab module loaded. Best bet is go back to your supplier for support.
-
Hi, When you create your toolpath, there is a check box "Inlay", uncheck this and you should get the sharp corners again. (Cut> Create Toolpath>Male).
Log in to reply.