• Uniform Printers

  print & cut mis-aligned

  Posted by Roy Roffey on 13 November 2009 at 17:44

  i am having trouble with my cadet print/cut alignment, it is out by a couple of mm when i print and cut with a bleed.

  Question is: would this be a printer setting or software setting? i have tried to tweek both but no joy??

  Has anyone else had this problem..

  thanks

  roffs

  Roy Roffey replied 16 years ago 3 Members · 4 Replies
• 4 Replies

• 

  Chris Wool

  Member

  13 November 2009 at 18:02

  go home early alright for some. 😀

  is this just print then cut or after its been removed and realigned

  if its out by the amount of bleed then surround the graphic with a hairline box. or send it on a defined page, rather than selected only.

  i am in in the morning if you are stuck

  chris

• 

  Roy Roffey

  Member

  13 November 2009 at 18:26

  lol, had a week off chris, went to cardiff for a holiday ????????

  typical cuse it was working fine when i left..ha ha..

• 

  Martin Oxenham

  Member

  14 November 2009 at 00:07

  I thought people went to Cardiff as punishment !

• 

  Roy Roffey

  Member

  14 November 2009 at 00:13

  :lol1: :lol1:
  na, i must say the city is well nice now, as well as that we went to see the wwe wrestling so loads of men in tights…just like the old cardiff !! 😉 😉

Log In to Reply