• Adobe Software

  Cutting Master help needed please

  Posted by Dave Ellis on 16 September 2009 at 10:26

  Hi all, I am hoping somebody can help me with a problem I have when using Cutting Master 2.

  I have installed the software and I am using illustrator CS3. My plotter is a graphtec CE5000-60.

  The problem I have is that no matter how big the design is in illustrator and the cutting master. when it is sent to the plotter it is only cutting a very small copy of the image.

  I am new to the cutting master aspect of the program and although I have read the instructions I cannot see where I am going wrong.

  Any help or advice would be greatly appreciated.

  Thanks
  Dave.

  Dave Ellis replied 16 years, 2 months ago 2 Members · 2 Replies
• 2 Replies

• 

  Chris Wool

  Member

  16 September 2009 at 10:31

  step size is incorrectly set on either the plotter or CM2

  both need to be 0.1mm

  chris

• 

  Dave Ellis

  Member

  18 September 2009 at 08:27

  Thanks Chris.

  Your advice was excellent and solved my problem straight away.

  Regards

  Dave.

Log In to Reply