• Roland Printers

  Problem With Test Print

  Posted by Paul Seamer on 20 October 2008 at 11:32

  Hi Guys,

  I have done a test print and it isn’t firing on all nozzles. What can I do? I have cleaned around the print heads.

  Please Help

  David Rogers replied 16 years, 11 months ago 1 Member · 1 Reply
• 1 Reply

• 

  David Rogers

  Member

  20 October 2008 at 12:21

  One option is a head soak.

  Switch off

  MANUALLY drop the capping stations.

  Push carriage out of way.

  Clamp off drain pipes.

  Fill capping stations with cleaning fluid.

  Push carriage back into position & wind up the capping stations.

  Leave for a few hours….

  UNDO THE CLAMP!!!

  Run a couple of clean cycles…test again.

  You can also do a ‘powerful clean’…but you’d better have a LOT of ink ready to waste 😥

  Dave

Log In to Reply