• General Cutter topics

  Advice needed please!

  Posted by Anna Lee on 13 May 2007 at 19:13

  Hi there!

  This is my first go on this site so please bear with me!!

  I have just been given a Summa D60, it has signlab 7 but no dongle!

  Any advice on how to get up and running.

  Thank you 😀

  Rod Young replied 18 years, 6 months ago 5 Members · 5 Replies
• 5 Replies

• 

  Karl Williams

  Member

  13 May 2007 at 19:53

  Buy a dongle or cut from coral.
  You can download the winplot from the summa website.

• 

  Martin Pearson

  Member

  13 May 2007 at 21:28

  If it’s a genuine version of signlab then cadlink might sell you a dongle for it but it won’t be cheap, Robert paid a lot of money to replace one he had lost.
  You might be better off buying a different program like corel to get yourself up and running unless you have deep pockets.

• 

  Jonathan McGovern

  Member

  14 May 2007 at 16:23

  I just had a replacement dongle for £105 inc VAT. I got mine through simon stanley at lettering systems unlimited.

• 

  Peter Normington

  Member

  14 May 2007 at 16:34

  To get a replacement you need the original,

  the dongle on its own is in effect the lisence for the program, so it will probably cost the same as a new program 🙁

  Peter

• 

  Rod Young

  Member

  15 May 2007 at 19:34

  Ask the person for the SignLab dongle. Perhaps it was merely overlooked and left connected to the previous computer. Most likely it was a USB dongle plugged into back of computer. Otherwise, it would have been a parallel port "pass thru" dongle.

  If the person is unable to provide you with dongle, then you’ll need to contact CADlink Sales.

  Regards,

  Rod at CADlink

Log In to Reply