• General Cutter topics

  2 plotters – 2 problems – HELP

  Posted by Vivienne Hennessy on 23 January 2007 at 21:51

  hi everyone i have 2 plotters

  A gerber fastrack 650 – which will not cut the correct size for me i presume this is something small and just a page width setting or something like that could anyone tell me if this would be the problem. I am cutting directly from coreldraw 10.

  A roland CM-24 – which for love nor money will not cut edges of letters only tears them have replaced the blade holder that i thought was the problem but no change. Any ideas anyone??

  Any help greatly appreciated….
  Thanks in advance,
  Viv.

  Chris Wool replied 18 years, 8 months ago 1 Member · 1 Reply
• 1 Reply

• 

  Chris Wool

  Member

  23 January 2007 at 23:51

  ideas

  in the driver you could have fit to page turned on.
  on some plotters in the menu is a scaling function.
  if sized correctly across the plotter but a bit out down the length then calibration.

  on the roland it still points towards the holder and blade if you can borrow one from any roland to prove a point.

  chris

Log In to Reply