• General Sign Topics

  aluminium swing panel supplier ?

  Posted by Derek Heron on 16 October 2006 at 11:13

  can you buy new panels for these if so where
  the one i have to replace is 500x 700 with two slots at the top approx 300 mm apart i have the old panel but it has been screenprinted
  tried covering in white vinyl but it shows through

  derek

  Derek Heron replied 19 years, 2 months ago 6 Members · 7 Replies
• 7 Replies

• 

  David Rogers

  Member

  16 October 2006 at 11:18

  Try coating it in black first…it covers a multitude of sins.

• 

  Derek Heron

  Member

  16 October 2006 at 11:32

  thanks dave tried it but you can see the raised print
  derek

• 

  Martin Cole

  Member

  16 October 2006 at 11:46

  Bought a few of these in the past from A-Display 023 9222 1222

  Just looked at size 825 x 520, tad bigger than you need may not make any difference. Can’t remember them being very expensive either.

  Martin

• 

  Neil Churchman

  Member

  16 October 2006 at 13:05

  Derek,

  have you considered removing the ink with screenwash or ink thinner?

  a lot of those panels are stove enamelled so there’s a good chance you
  can clean the ink off, although you should check a small area first.

• 

  Lee Attewell

  Member

  17 October 2006 at 09:31

  Wet and dry the edges of the text, and use a grey backed blockout vinyl to cover???

  Would that help?

• 

  Nick Harper

  Member

  30 October 2006 at 15:52

  It sounds like a Eurasign Panel, which are available from Spandex – 0800 772633.
  I know the panels are 700 x 500. Not sure about the gap between the holes though. I think it’s only about 220mm on them.

  But you can get spare panels.

  Might be worth a try.

  Nick

• 

  Derek Heron

  Member

  30 October 2006 at 18:37

  hi decided to cut a new bit from alupanel offcut
  customer over the moon kept the old one to stick on the wall will ring spandex thanks for the pointers

  Derek

Log In to Reply