• General Printing Topics

  Contour cutting problem

  Posted by Ian Higgins on 11 October 2006 at 10:52

  Hi folks

  Have a problem with contour cutting on my Cadet. After it prints it is then cutting but it is about 3mm out!

  doing a load of small circles but it is terrible!

  never had the problem before, any advice appreciated

  Ian

  Gordon Forbes replied 19 years, 2 months ago 5 Members · 7 Replies
• 7 Replies

• 

  Robert Berwick

  Member

  11 October 2006 at 10:56

  Ian – your not using a new profile are you? I think theres an offset option in there which may be incorrectly set.

  Robert

• 

  Derek Heron

  Member

  11 October 2006 at 11:40

  hi ian just had a similar problem with my cadet
  and went through the menu
  automatically correcting misalignment of the printing and cutting positions
  seems to have done the trick
  if you need the step by step instructions i can send them to you

  Derek

• 

  Ian Higgins

  Member

  11 October 2006 at 12:02

  Hi Derek,

  Can you please send them
  regards

  Ian

• 

  Chris Wool

  Member

  11 October 2006 at 12:25

  if the cadet 54 has a environmental check do that first before doing any adjustments as it may only require the check.

  chris

• 

  Ian Higgins

  Member

  11 October 2006 at 12:28

  Hi Chris,

  Already tried that one..
  Thanks though

  Ian

• 

  Derek Heron

  Member

  11 October 2006 at 15:43

  hi ian just got back in will post pic of the page of instructions as cant post it here hope it helps

  derek

• 

  Gordon Forbes

  Member

  19 October 2006 at 17:04

  I reckon you need to get into the service menu and do it properly from there. I found the menu command at best useless. Got a tech to do it for me and have done it myself since

  Goop

Log In to Reply