• Flexi Sign Software

  Is anybody running a Creation PCut plotter off Flexisign?

  Posted by Martin Manley on 4 June 2006 at 19:28

  Is anybody running a Creation PCut plotter off Flexisign instead of it’s own woeful Artcut software? When I try, Apart from cutting everything in reverse (which I can get around) the plotter knife won’t lift after cutting a letter and leaves the movement lines as cut lines, therefore buggering up the whole job.
  Any suggestions? (:)

  Martin Manley replied 19 years, 4 months ago 3 Members · 3 Replies
• 3 Replies

• 

  Garrie

  Member

  6 June 2006 at 12:29

  thats weird, have you tried the cutter with Artcut or any other software, does the head lift then? Can you lift the head using the control panel on the cutter?

  I have the settings I use with Flexi and it all cuts fine

• 

  Glen Mathers

  Member

  6 June 2006 at 19:53

  Seems to me that your using the wrong drivers. Have you tried this site for drivers?
  http://www.signsupplystore.com/productc … ubmit.y=12

  hope it helps.

• 

  Martin Manley

  Member

  21 June 2006 at 18:10

  Thanks folks,
  Just back from holiday so haven’t had a chance to try out your ideas yet –
  Martin 🙄

Log In to Reply