Find answers, ask questions, connect with our community.

Activity Feed Forums Sign Discussion General Sign Topics Speeding up Solvent Cure times Reply To: Speeding up Solvent Cure times

  • Elena kalispera

    Member
    June 10, 2011 at 10:29 pm

    Honestly a really interesting read. My husband has always done it the way Rob suggested hanging short side with a fan above pointing down and extraction at the bottom. The question arose because this friend of ours has only just started to do it this way and we felt we advised Him correctly by saying its not going to work. But he has assured us it’s been ok the last few times he’s done it. Incidentally he uses Rtl inks so maybe there is something in the suggestions of inks and profiles that may also help?
    Maybe the heat from the laminator accelerates the evaporation or fall of solvent gas??

    I have to point out the process he uses is to run it through a laminator alone with no lamination first then he laminated it after . I should have explained more clearly in my first post

    Elena