Find answers, ask questions, connect with our community.

Activity Feed Forums Sign Discussion General Sign Topics advice on fitting a sign tray Reply To: advice on fitting a sign tray

  • John Harding

    Member
    January 11, 2011 at 10:01 am

    general answer – if its a wooden shop fascia I whack loads of screws through the angle into the fascia knowing the wood will deteriorate over time – however you only need a few to hold the tray to the angle as there nothing to rot so the screws you see will be minimal.

    If you need to ask – its not a stupid question – because you don’t know the answer

    However like many you suffer from no photo avatar which is proven to get you less response’s – so there’s my tip (not just to you but anyone else reading this to whom it may apply) – if your committed to signs and UKSB post a picture – if not don’t be disappointed by the read/response rate (!)

    John 😀