MemberDecember 14, 2010 at 12:55 pm
Yes we cut accross the flutes so they ran vertically for a bit more strength.
Just score through the top surface and halfway through the flutes and when folded they snap and hinge along the remaining surface.
The diagram is the dimensions we used and sent to our printer for an A1 print on each side, 2 can be cut from an 8`x 4` sheet.
You can see at the bottom of each print the base folds over and they overlapped each other.
If you use velcro strips on the base overlaps they can be dismantled and stored flat.
Using the face of the correx as a hinge seems quite strong for temporary use and it can stand being folded flat and then reused.
all the best