Find answers, ask questions, connect with our community.

Activity Feed Forums Software Discussion General Software Topics Anyone using onyx? or specifically onyx 11? Help with tiling options Reply To: Anyone using onyx? or specifically onyx 11? Help with tiling options

  • Kev Mayger

    Member
    September 3, 2020 at 12:26 pm

    Hi Martin

    Either way is correct. Open your job in Onyx Job Editor and go to the 3rd tab along Tiling set up. Click enable tiling, this will allow you to set your panel sizes and overlap. If you choose 60mm overlap you will get 30mm bleed.