Find answers, ask questions, connect with our community.

Activity Feed Forums Cutter Discussion Roland Cutters Roland SP300V Not cross cutting the vinyl, advice please? Reply To: Roland SP300V Not cross cutting the vinyl, advice please?

  • Chris Wool

    Member
    August 25, 2020 at 6:29 pm

    i would be tempted to switch the machine off completely then separate the cutting head from the print head and operate the cutter head manually to see if it is traveling all the way to lock it down think its only being partly locked down.

    if the cable is slightly slack then could cause this or wear on the sheet cut mech. or even a bit sticky.

    unfortunately the service command limit adjust also resets the head capping and lock position so needs a lot of care