Find answers, ask questions, connect with our community.

  • versawork 5 advice

  • Lynn Wang

    Member
    December 6, 2021 at 4:45 pm

    hi

    we are currently running versawork 5 , roland rs 640

    how to set the inverval 0cm between jobs?

    it used to be as below , no gap between jobs

    https://photos.app.goo.gl/XtgT3GL852aZMWU19

    but now , it is as below , big gap between jobs

    https://photos.app.goo.gl/ZGRdafEeN87JvDML8

  • David Stevenson

    Member
    December 6, 2021 at 11:41 pm

    Hi Lynn, this image is from VW6 but it should be in the same location in VW5. Simply change the page space to 0mm for no gap. Personally I wouldn’t recommend this. I know over time it adds up to some wasted material but it provides you with a much needed break in the event you’ve a problem with your laminator or are about to run out of laminate. Today for example when laminating a large roll of material for a van wrap I was able to use the remains of 3 rolls instead of having to open a new roll. Had I had no gaps these 3 rolls would have lay in the corner un-used. They’d a combined value of approx £100 so worth using up.

  • Lynn Wang

    Member
    December 8, 2021 at 4:46 pm

    <div>thanks , David Stevenson</div><div>

    i set as below ,

    https://photos.app.goo.gl/s7w63XkAG8RG4hUD8

    but it is still same , big gap between jobs

    thanks

    </div>

Viewing 1 - 3 of 3 replies

Start of Discussion
0 of 0 posts June 2018
Now