Activity Feed Forums Printing Discussions Roland Printers Roland Versacamm, Actual Print measurement, advice?

  • Roland Versacamm, Actual Print measurement, advice?

    Posted by Daniel Evans on October 13, 2018 at 2:44 pm

    Has anyone actually measured artwork they print?

    I needed to print something and line it up with something printed on another printer.

    I couldn’t get it to match and the measurements printed on the versacamm were a few mm out. On the basis that I had the heater on, I thought this may have been the problem so I printed it again without the heater and no difference.

    The size should be 430mm x 611mm but i’m getting 3mm short

    Can this be adjusted?

    I should say it’s only on the feed part, I’m actually thinking it could be the feed that’s messing this up

    Stafford Cox Stafford Cox replied 3 years, 7 months ago 2 Members · 2 Replies
  • 2 Replies
  • Daniel Evans

    Member
    October 13, 2018 at 4:06 pm

    Ignore that.

    I was just having a moment, of course it was down to the feed.

  • Stafford Cox Stafford Cox

    Member
    October 14, 2018 at 6:45 am

    Well done Dan. Always use crop marks too in case there’s a white space in the customers artwork.