Find answers, ask questions, connect with our community.

Activity Feed Forums Sign Making Discussions File Swapping rally stripe templates for a 2012 camaro

  • rally stripe templates for a 2012 camaro

     Robert Lambie updated 1 week, 1 day ago 4 Members · 7 Posts
  • George Elsmore

    Member
    April 27, 2021 at 8:25 am

    Hi All, long time no see, i am after the above can anyone point me in the right direction please

  • Jeff Rea

    Member
    April 27, 2021 at 8:49 am

    Quickest and easiest way would be knifeless tape.

    you should have a bit of experience using the stuff but its straightforward enough to use. I would line out one of the stripes with the knife tape and apply a full panel of wrap for that stripe and then pull it thru. the difficult bits might be the little turns at the end of the panel because there is only so tight you can take it.

    • George Elsmore

      Member
      April 27, 2021 at 9:35 am

      Thanks for the reply Jeff I would rather cut it as it would look far better

  • Jeff Rea

    Member
    April 28, 2021 at 12:58 pm

    Yeh i agree with you George, no beating it being cut in a machine mate.

  • Kevin Mahoney

    Member
    April 28, 2021 at 1:57 pm

    Checked my files for this George, had a feeling we’d done these before but could only find a set for a Mustang. Is it worth tracing the jpg you’ve attached & scaling up on the day of installation?

    • George Elsmore

      Member
      April 28, 2021 at 2:11 pm

      I have drawn it now thanks Kev

  • Robert Lambie

    Administrator
    May 3, 2021 at 10:50 am

    These pictures are from an old post on UKSB but I did these Mustang Graphics. complete pain in the rear end. this was before the likes of knifeless-tape. looks simple enough but wasn’t! 😏

Log in to reply.

Original Post
0 of 0 posts June 2018
Now