Activity Feed Forums Printing Discussions Roland Printers Possible calibration needed?

  • Possible calibration needed?

    Posted by Dan Giddings on June 28, 2019 at 8:14 am

    Hi all
    I’ve attached a photo of a test print from my sp300v, do I need to be performing some sort of calibration to sort the gap in the middle, If so, which one should I do?
    Many thanks


    Attachments:

    Dan Giddings Dan Giddings replied 2 years, 10 months ago 2 Members · 2 Replies
  • 2 Replies
  • Chris Wool

    Member
    June 28, 2019 at 10:30 am

    adjustment required is feed calibration normal vinyls 0 thinner cast + a bit thick banner – a bit think thats the right way round. if you alter the machine make sure vw is not over riding the value.
    some profiles have a feed value set but check if use machine value is active or not as required

  • Dan Giddings Dan Giddings

    Member
    June 28, 2019 at 10:35 am

    Thanks Chris I’ll perform the feed calibration and retest.