Activity Feed › Forums › Vinyl Cutter Discussions › PCUT Vinyl Cutters › Pcut setup using coreldraw

  • PCUT Vinyl Cutters

    Pcut setup using coreldraw

    Posted by Wayne aspinall Wayne aspinall on September 23, 2017 at 6:34 am

    I’ve owned this pcut 0630 for a while. It was set up on my laptop by the sellers when I bought it. However, the computer died and I now need to set it up again.
    I have lost the installation disc for the plotter and have purchased coreldraw x6. I have installed coreldraw and tried to cut out a project. I’m not sure what I’m doing as it’s so long since I used it before. Do I need a cutting software to interface with the cutter. Some say you can use the cutter as a printer but I can’t find the cutter in printers.
    Any help welcome

    Jonathan feeney Jonathan Feeney replied 5 years ago 1 Member · 1 Reply
  • 1 Reply

  • Jonathan feeney Jonathan Feeney

    Member
    September 23, 2017 at 9:17 pm

    I use sign blazer along side corel and im led to believe it’s a free software cheers

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this