Find answers, ask questions, connect with our community.

Activity Feed Forums Printing Discussion Mimaki Printers JV3 Metamark and Signlab RIP

  • JV3 Metamark and Signlab RIP

  • Malcolm Johnston

    Member
    April 24, 2019 at 10:14 pm

    Hi there, I’m a newbie to the forum, and this is my 1st post. Wondering if anyone else is using a JV3 to print Metamark vinyls via Signlab ver 9.1 RIP. I’m struggling to get decent colours on my prints.

  • Denise Goodfellow

    Member
    April 25, 2019 at 7:20 am

    We only use the jv3 for banners, I think we use an oracal profile

  • Malcolm Johnston

    Member
    April 25, 2019 at 11:03 am

    Thanks Denise, any idea which one and I’ll give it a go?
    Do you output directly to the vpm? I’ve not been getting good results doing that, even outputting the design as a pdf and then dragging this into the rip doesn’t give the right colours.
    In desperation I tried outputting the design as an eps file and dragging this into the rip and it gave much better results … so I think I’m getting somewhere, if I could try the oracal profile with the eps it might just do the trick !

  • Colin Crabb

    Member
    April 25, 2019 at 11:42 am

    Have you as your Metamark rep for the profiles?

  • Malcolm Johnston

    Member
    April 25, 2019 at 9:10 pm
    quote Colin Crabb:

    Have you as your Metamark rep for the profiles?
  • Malcolm Johnston

    Member
    April 25, 2019 at 9:11 pm
    quote ButeSigns:

    quote Colin Crabb:

    Have you as your Metamark rep for the profiles?
  • Malcolm Johnston

    Member
    April 25, 2019 at 9:12 pm

    I’ve tried the Metamark profiles, they’ve not been tested by Metamark and they are for signlab ver 7

  • Andrew O Brien

    Member
    April 29, 2019 at 9:02 pm

    Just wondering,why would you not just use rasterlink?

Log in to reply.

Original Post
0 of 0 posts June 2018
Now