Find answers, ask questions, connect with our community.

Activity Feed Forums Vinyl Cutter Discussions Graphtec Vinyl Cutters Graphtec-CE5000-60 HP360 Latex and ONYX RIP/CUT Server

  • Graphtec-CE5000-60 HP360 Latex and ONYX RIP/CUT Server

     Robert Lambie updated 2 years ago 1 Member · 2 Posts
  • Mike Wilkinson

    October 7, 2019 at 12:25 pm


    Can anyone advise me on setting up a print / cut file. I’ve just bought a secondhand Graphtec CE5000-60 and I’m using a HP360 Latex and ONYX RIP.

    I’ve printed the document and named the cut path as ‘CutContour’ using a spot colour in illustrator and the ONYX RIP recognises the cut paths but when I load the material and set the optical eye over one of the registration marks, I get ‘MarkScan Error’ message on the Graphtec after I clicked Cut Path in ONYX. If I then press enter on the cutter, it starts cutting the paths at around 500% larger than what it should be. :bangshead:



  • Robert Lambie

    October 10, 2019 at 6:52 am

    I do not use Illustrator for this type of thing, it would be done in Signlab, but the same principle.
    could the issue not be your sizing within Illustrator as I know it has limits to its sizes.
    In Signlab it’s very straight forward. apply the contour cut and export as a PDF. etc. etc…

Viewing 1 - 2 of 2 replies

Log in to reply.

Original Post
0 of 0 posts June 2018