Find answers, ask questions, connect with our community.

  • Gold Star

  • Richard Urquhart

    Member
    November 9, 2007 at 1:43 pm

    hi all looking for a gold star that can be printed not cut I would like something 3d looking may be a bevel to it
    thanks rich 😀

  • George Elsmore

    Member
    November 9, 2007 at 1:47 pm

    do you use coreldraw Rich?

  • Richard Urquhart

    Member
    November 9, 2007 at 1:48 pm

    i do
    but cant draw !!!! 😮

  • George Elsmore

    Member
    November 9, 2007 at 1:49 pm

    any good?


    Attachments:

  • Richard Urquhart

    Member
    November 9, 2007 at 1:52 pm

    thanks mate will have a look asap just not at my pc so will have to wait till i get back thanks rich
    😀

  • Richard Urquhart

    Member
    November 9, 2007 at 2:57 pm

    hi mate that’s the sort of thigh I’m after , this one looks like there are loads of lines in the image ???

  • George Elsmore

    Member
    November 9, 2007 at 2:59 pm

    If you zoom right in they disappear i am sure it prints ok, print a small sample to see mate

  • Richard Urquhart

    Member
    November 9, 2007 at 3:02 pm

    will run a print mate i just got back to the office and i need to warm my hands up !!!
    best bit about the printer is the dryer

  • George Elsmore

    Member
    November 9, 2007 at 3:14 pm

    heres a bitmap tweaked version too

  • Richard Urquhart

    Member
    November 9, 2007 at 7:49 pm

    thanks mate
    worked a treat
    rich 😀 😀

Log in to reply.

Original Post
0 of 0 posts June 2018
Now