Signlab e6 & Gerber Edge - General Software Topics - uksignboards.com

General Software Topics

Signlab e6 & Gerber Edge

Posted by Gary Threlkeld on May 15, 2016 at 11:41 am

Hi all, any help from those running Signlab along with the Gerber Edge would be appreciated.

We’re very experienced Edge users and currently run three of them (Omega). We have recently purchased an Edge along with a PC with Sign lab e6 loaded (legit with the dongle). The Edge is printing spot colours very well and we have no problems with the PC, software or Edge.

Here is the problem we have. We have a greyscale bitmap (jpg) which we do not wish to CMYK (process) print. We want to print it with just a spot black foil (perfectly easy with Illustrator or Omega). Any experienced Edge users will know what I am talking about.

Pulling my hair out on this so any help is most appreciated.

Thanks

Gary Threlkeld replied 7 years, 11 months ago 2 Members · 2 Replies
2 Replies

Denise Goodfellow

Member
May 15, 2016 at 6:48 pm

I think……

You change the bitmap to multi tone bitmap, then change the colour by clicking on a spot colour

Could be wrong
Gary Threlkeld

Member
May 15, 2016 at 7:19 pm

Thanks Denise … I’ll be sure to give that a try when I am down at the office tomorrow.

Anymore advice is most appreciated.

:thumbup2: :thumbup2:

Log In to Reply

Log in to reply.