Activity Feed › Forums › Sign Making Discussions › Neon, LED, Lighting › Scaling down images to RIP/print, advice please?

  • Neon, LED, Lighting

    Scaling down images to RIP/print, advice please?

    Posted by Chris Wilson on November 23, 2018 at 7:57 pm

    Hey folks,

    As per the title I’ve always (in my limited time on this job) exported all files at full size from Corel draw as a EPS and then imported into versaworks. This has always worked ok, sometimes they take a few minutes to rip or exports but nothing drastic, on the other hand I think our biggest sign with fair detail is 10m x 2.5m so not massive.

    However today I am having a nightmare with a very complex print for the side of the van. It’s only 3.6m x 1330mm.
    Tried scaling it down to 10% then blowing up to full size in versaworks. Result was dreadful. Tried 50% pretty much the same/took ages.

    Just wondering what am doing wrong. Clearly something. As I know others have and must do unless you all have NASA sized computers.

    Chris Wilson replied 5 years, 5 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .