Posted by Alan Pattison on December 14, 2016 at 6:32 am
Morning all, I’m looking at expanding into routing our own bits n pieces rather than wait for it to be done off site. Typically, I’ve been looking at gerber sabre 408 or axyz machines, what’s your views on these?
We’ve had our 408 for probably getting on for about 12 – 14 years now. Rarely gives us any problems (but we have the monthly service contract just in case). Good, well built machine but the artpath software running it is a bit outdated now but the Omega graphics software is very good.
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.