Posted by Warren Beard on July 27, 2016 at 8:47 pm
Hi All
Looking to build a print drying table with some fans below to suck the air through to aid outgassing. Can anybody recommend and few hints and tips to building one and what fans do you recommend?
I built a vertical ply box around 500×500 and 1700 high. There’s a bathroom extractor underneath pulling air down through a mesh. Works really well and runs most days with loose rolled vinyl inside. I Plan to put an air filter on top at some point but not had any issues with dust yet. I will put some pics on tomorrow
I will try and get a demo loaded i have had queued for a while now, "amongst others". It illustrates exactly how i overcome this issue before moving to UV and Latex Printing which in the past was a big issue for me running a minimum of 5 truck wraps a week amongst daily work load.
In a nutshell, hang your prints!
Solvent is heavier than air and drops, not rises.
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.