Activity Feed › Forums › Printing Discussions › Mimaki Printers › Mimaki firmware advice, can someone help please?

  • Mimaki Printers

    Mimaki firmware advice, can someone help please?

    Posted by David King on September 17, 2017 at 11:08 pm

    Can anyone explain in detail how to downgrade the firmware so that I can use a normal DX5 printhead on my CJV30-100?
    I bought a used Mimaki CJV30-100. Printhead shorted out and destroyed the slider and mainboard. So I bought a new slider board and replaced it, mainboard I have sent to MAC MEDIA USA to be repaired. Now my big problem is the PRINTHEAD! Should I buy a new Mimaki DX5 Printhead or a OEM Epson DX5 and downgrade the firmware so that the printhead would work? Anyone here have the experience to how to do this? "2nd question: Where can I get the 2.2 firmware and where can I get the FIRMWARE TOOL to do this?

    Thank you for your help and comments in advance.

    David King replied 6 years, 7 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .