Activity Feed › Forums › Printing Discussions › Mimaki Printers › JV3 Metamark and Signlab RIP
-
JV3 Metamark and Signlab RIP
Posted by Malcolm Johnston on April 24, 2019 at 10:14 pmHi there, I’m a newbie to the forum, and this is my 1st post. Wondering if anyone else is using a JV3 to print Metamark vinyls via Signlab ver 9.1 RIP. I’m struggling to get decent colours on my prints.
Andrew O Brien replied 4 years, 12 months ago 4 Members · 7 Replies -
7 Replies
-
We only use the jv3 for banners, I think we use an oracal profile
-
Thanks Denise, any idea which one and I’ll give it a go?
Do you output directly to the vpm? I’ve not been getting good results doing that, even outputting the design as a pdf and then dragging this into the rip doesn’t give the right colours.
In desperation I tried outputting the design as an eps file and dragging this into the rip and it gave much better results … so I think I’m getting somewhere, if I could try the oracal profile with the eps it might just do the trick ! -
quote Colin Crabb:Have you as your Metamark rep for the profiles?
-
quote ButeSigns:quote Colin Crabb:Have you as your Metamark rep for the profiles?
-
I’ve tried the Metamark profiles, they’ve not been tested by Metamark and they are for signlab ver 7
-
Just wondering,why would you not just use rasterlink?
Log in to reply.