-
Graphtec FC7000Mk2-160 older firmware version
Hi all.
I was having issues reading the registration marks with my cutter so I updated the firmware to v3.90GL as a general ‘lets start with the basics’ sort of approach.
I resolved the issues but not by the firmware upgrade. However, ever since then, I keep getting stupid issues with the cutter – intermittent pausing waiting for a ‘continue with job’, the screen sometime goes blank and I have to power off/on again, or the whole thing freezes/locks up again requiring a power off/on again. Never had these issues before the firmware upgrade.
I was just wondering if anyone just happened to have the previous version (v3.80) stored away on a PC or pen drive.
I’ve looked on t’interweb but have been unable to find it anywhere.
Thanks,
Pete J.
Sorry, there were no replies found.
Log in to reply.