Activity Feed › Forums › Printing Discussions › Uniform Printers › 0.75mm plasticard.

  • Uniform Printers

    0.75mm plasticard.

    Posted by Gary Thornton on February 13, 2016 at 11:18 am

    Hi guys.
    I’ve just had an inquiry asking if my uniform cadet 1400c (sp540v versacamm in disguise) can cut 0.75mm plasticard.
    I have had no dealings with this material so wondered if anyone can advise me.

    Many thanks in advance

    Gary Thornton replied 8 years, 2 months ago 2 Members · 2 Replies
  • 2 Replies

  • Kevin Flowers

    Member
    February 13, 2016 at 3:16 pm

    Gary
    think you would need flatbed cutter for that

    Kev

  • Gary Thornton

    Member
    February 13, 2016 at 5:32 pm

    O.K. Thank you for the reply Kev.

    It’s cleared that up for me. :thumbup2:

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .